Xerox 7228 用户指南

28 

9.  On the Protocol Settings menu, press the selection line labeled Ethernet Setting. 

10. Press the Change Settings button. 

11.  On the settings screen, note which one of the buttons is highlighted as the current setting for Ethernet 

Speed. The available settings are Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX (Half or Full 
Duplex), and 10 BASE-T (Half or Full Duplex).  By default the Ethernet Port Configuration will be set 
to Auto. 

12.  To change settings, press your setting of choice, then press the Save button. 

13.  To exit the screen, without making any changes, press the Cancel button. 

14.  On the Protocol Settings menu, press the selection line labeled TCP/IP - Get IP Address. 

15.  Press the Change Settings button. 

16.  On the settings screen, note which one of the buttons is highlighted as the current setting for the 

TCP/IP Addressing method.  The available settings are DHCP, BOOTP, RARP, DHCP/Autonet, and 
Manual.  DHCP/Autonet is the factory default setting. 

17.  To change settings, press your selection of choice, then press the Save button. 

18.  To exit the screen, without making any changes, press the Cancel button.