Xerox 7228 用户指南

下载
页码 300
58 
EtherTalk (AppleTalk) Configuration   
B7
 
The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk) 
network. 
To access EtherTalk Settings at the Device 
1. Press 
the 
Log In / Out button
 on the Control Panel. 
2. Press 
the 
"1" key
 on the numeric keypad five consecutive times.  (This is the factory default 
"password.") 
3.  Press the rectangular Confirm button on the touch screen. 
4. Press 
the 
System Settings button
 (the right-hand button of the two buttons displayed on the touch 
screen).  Note:  If you press the left button by mistake, the Main menu will be displayed and you will 
have to start over at step one above. 
5. Press 
the 
System Settings button
6. Press 
the 
Network Settings button
7. Press 
the 
Port Settings button
 to access the Port Settings menu. 
8. Press 
the 
EtherTalk
 selection line on the Port Settings menu. 
9. Press 
the 
Change Settings button
 in the lower right corner of the Port Settings menu screen. 
10.  When the EtherTalk selection menu displays, note that you have only one selection available on a 
single, numbered horizontal line, with the current status of this setting shown.  The Close button in the 
upper right corner of the screen returns you to the Port Settings menu.  After pressing the horizontal 
line selection, to access available settings press the Change Settings button in the lower right corner 
of the touch screen.