Xerox wc7530 用户指南

Installation and Setup 

 

30 

WorkCentre 7500 Series Multifunction Printer 

 User 

Guide 

 

Installation and Setup Overview 

Before printing, your computer and the printer must be plugged in, turned on, and connected to an active 

network. The system administrator must configure the initial settings of the printer before installing the 
driver software. The driver software and utilities must be installed on your computer. 

For details on configuring the printer network settings, see the 

System Administrator Guide at 

www.xerox.com/office/WC75xxdocs

. 

 

Physical Connection 

Use a Category 5 or better Ethernet cable to connect the printer to the network. An Ethernet network is 
used for one or more computers and supports many printers and systems simultaneously. An Ethernet 

connection is typically faster than a USB connection and provides direct access to printer settings using 
CentreWare Internet Services. 

To connect the printer: 
1.  Connect the power cord to the printer, and plug the cord into an electrical outlet. 
2.  Connect one end of a Category 5 or better Ethernet cable to the Ethernet port on the printer. 

Connect the other end of the Ethernet cable to the network port. 

3.  Connect a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to the printer and to a 

functioning telephone line to support Faxing. 

 

 

Turning the Printer On 

This printer has two power switches. The switch located on the top of the printer, beneath the control 
panel, controls power only to the electronic components of the printer. The second switch, located behind 

the front cover, controls the power into the printer. Turn on both switches to operate the printer. First turn 
on the power switch behind the front cover, then turn on the top switch.