Xerox C118 用户指南

Continue with Test Print on page 47.

Follow the steps below to use the HP System Administrator Manager (SAM) GUI 
(Graphical User Interface).

NOTE: Refer to the HP-UX documentation for additional information on using the 
System Administrator Manager (SAM).

Start the SAM application.

Select the [Printers and Plotters] icon.

Select [Actions] from the Menu Bar.

Select [Add Remote Printer/Plotter] form the pull-down menu.

Enter the following information into the form displayed in the [Add Remote Printer/
Plotter] dialog box:

1) Printer Name

2) Remote System Name

3) For the Remote Printer Name, enter “lp”.

NOTE: The Printer Name is the name of the print queue being created. The Remote 
System Name is the PrinterName for the machine from the etc/hosts file.
The Remote Printer Name must be set to "lp" to spool jobs to the machine.

4) Enable Remote Printer on a BSD system by selecting the check box.

5) Make sure that the [Remote Cancel Model] is set correctly,

6) Make sure that the [Remote Status Model] is set correctly.

7) Make sure that the [Default Request Priority] is set correctly.

8) Make sure that the [Allow Anyone to Cancel a Request] check box is set 

correctly.

9) Make sure that the [Make This Printer the Default Destination] check box is set 

correctly.

Select [OK].

Read and respond to any displayed system messages.

Continue with Test Print on page 47.

To make sure that the machine has been installed on the UNIX TCP/IP network 
correctly, a test print should be submitted from a client workstation. Perform the 
following steps.

Start the Open Windows application.

Send a test print to the machine.