Xerox pro 16p 用户指南

The Printer Driver Installation software cannot be installed using the Add Printer Wizard for early
releases of Win 95 and NT 4.0.  Please use one of the following methods depending on your
operating system.

1.  Ensure that the computer and the Pro 16p are turned

off.

2.  Plug the IEEE-1284 cable into the parallel port on the

Pro 16p.

3.  Plug the other end of the IEEE-1284 cable into the

computer.

4.  Ensure that the power cord is plugged into the Pro 16p and then into a grounded outlet.

•

 

Do not attach your Pro 16p to a pass-through port of another device (scanner, CD-ROM
drive, tape drive, Zip

™

 drive or external disk).

5.  Turn on the PC.
6.  Start Windows on your computer.
7.  Insert the WorkCentre Pro Series CD-ROM into the CD-ROM Drive.

Note:  For Windows 95 and NT 4.0, go to step 8 of the Installation procedure on the next page
for the software version that you are running.  For Windows 98, go to the Plug-n-Play driver
installation on the next page.

1.  Turn off the computer and the Pro 16p.

2.  Plug the USB cable into the Pro 16p USB port.

3.  Plug the other end of the USB cable into the PC USB port.

4.  Ensure that the power cord is plugged into the Pro 16p and

then into a grounded outlet.

5.  Turn on the Pro 16p and the PC, and wait for Windows 98 to start.
6.  When the Add New Hardware Wizard screen appears, insert the WorkCentre Pro PCL

Software CD-ROM into the CD-ROM drive.

7.  Follow the Wizard instructions to install the USB driver.

Note:  Go to the Plug-n-Play driver installation on the next page.