Xerox xi70c 用户指南
41
Using your WorkCentre as a Copier
(continued)
Xi70c Bypass Tray
The exit tray doubles as a feed tray for up to five standard weight
(80 gr/m
2
) sheets of media and can be used to insert media that is different
in type and size from those in the main feeder.
Special media and envelopes should be fed one at a time. If you use
envelopes, before inserting them, make sure the edges and closing flap are
well creased, and that the flap lies flat. See media section for descriptions.
Special media and envelopes should be fed one at a time. If you use
envelopes, before inserting them, make sure the edges and closing flap are
well creased, and that the flap lies flat. See media section for descriptions.
Operating steps:
1. Remove any printed documents from the exit tray and open the lateral
and rear guides completely.
2. Load maximum five pieces of media
face down on the tray aligning its
leading edge against the feed rollers.
leading edge against the feed rollers.
3. Close the adjustable margin guides
against the edges.
4. If you are using the WorkCentre in copier mode, place original face
down on document glass and press START.
If you are using the WorkCentre in printer mode, select “Manual Paper
Source” in the Paper/ Output tab in the properties screen.
If you are using the WorkCentre in printer mode, select “Manual Paper
Source” in the Paper/ Output tab in the properties screen.
Remove the copy from the output tray as soon as it exits from the
WorkCentre. If you do not remove the output it may be displaced back into
the WorkCentre.