Gestetner c7528 操作指南

Monitoring and Configuring the Printer

234

msh> set http

msh> set rendezvous

msh> set nbt

msh> set ssdp

msh> set parallel

msh> set bluetooth

msh> set usb

msh> set device

❖ Configuration

• Enter “up”to enable protocol, and enter “down” to disable protocol.
You can set the protocol to “active” or “inactive”.

msh> set tcpip {up | down}

• If you disable TCP/IP, you cannot use remote access after logging off. If

you did this by mistake, you can use the control panel to enable remote ac-
cess via TCP/IP.

• Disabling TCP/IP also disables ip1394, lpr, ftp, rsh, diprint, web, snmp, ssl,

ipp, http, and rendezvous

msh> set appletalk {up | down}

msh> set netware {up | down}

msh> set smb {up | down}

msh> set scsiprint {up | down}

• scsiprint is available when the optional IEEE 1394 interface board is in-

stalled.

msh> set pictbridge {up | down}

• pictbridge can be specified only when the pictbridge is installed.

msh> set ip1394 {up | down}

• ip1394 can be specified only when the IEEE 1394 interface is installed.

msh> set lpr {up | down}

msh> set ftp {up | down}

msh> set rsh {up | down}

msh> set diprint {up | down}

msh> set web {up | down}

msh> set snmp {up | down}

msh> set ssl {up | down}

• If Secured Sockets Layer (SSL, an encryption protocol) function is not

available for the printer, you cannot use the function by enabling it.

msh> set nrs {up | down}

msh> set rfu {up | down}