ONKYO ht-r500 说明手册

13

• Refer also to the instruction manuals of the speakers.

• Be sure to connect the positive and negative cables for the

speakers properly. If they are mixed up, the left and right
signals will be reversed and the audio will sound unnatural.

• Connect speakers with an impedance between 6 

Ω and 16 Ω

Connecting speakers with an impedance less than 6 

Ω may

damage the HT-R500.

• To prevent damage to circuits, never short-circuit the positive

(+) and negative (–) speaker wires.

Loosen the
screw.

Fully insert the
end of the
cable.

Tighten the
screw.

• Do not connect more than one speaker cable to one speaker

terminal. Doing so may damage the HT-R500.

• When you are using only one speaker or when you wish to

listen to monaural (mono) sound, a single speaker should never
be connected in parallel to both the right and left channel
terminals simultaneously.

Press and hold
the lever.

Insert the stripped
end of the cable.

By releasing the
lever, the lever is
replaced.

5/8” (15 mm)

3/8” (10 mm)

Strip 5/8” (15 mm) from the end of each
cable, then twist the exposed wires tightly.

Strip 3/8” (10 mm)
from the end of
each cable, then
twist the exposed
wires tightly.

Use the SUBWOOFER PRE OUT
jack to connect a subwoofer with a
built-in power amplifier.

If your subwoofer does not have a
built-in amplifier, connect an
amplifier to the SUBWOOFER PRE
OUT jack and the subwoofer to the
amplifier.