ONKYO tx-sr308 用户手册

En

• Do not assign the component connected with the HDMI input to 

the TV/CD selector when you set “TV Control” setting to 
“On”. Otherwise, appropriate CEC (Consumer Electronics Con-
trol) operation is not guaranteed.

• Set  to 

“

”

 when the TV is not compatible or when it is unclear 

whether the TV is compatible or not.

• The 

“TV Control”

 setting can be set only when the above 

“

”

 and 

“Power Control”

 settings are both set 

to “On”.

• Refer to the connected component’s instruction manual for 

details.

You can change various audio settings by pressing 
AUDIO.

• When the “Audio TV OUT” setting is set to “On” (

32), 

AUDIO is disabled.

You can adjust the bass and treble for Speakers A and B 
front speakers, except when the Direct listening mode is 
selected.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut low-frequency sounds output 
by the front speakers.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut high-frequency sounds output 
by the front speakers.

• To bypass the bass and treble tone circuits, select the Direct lis-

tening mode.

• This procedure can also be performed on the AV receiver by 

using its TONE, –, and + buttons (

36).

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to Standby. To save the setting you made 
here, go to “Level Cal (Level Calibration)” (

31) before 

setting the AV receiver to Standby.

■

`

–15 dB to 0 dB to +12 dB in 1 dB steps

■

`

–12 dB to 0 dB to +12 dB in 1 dB steps

• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “Sp Config 

30) cannot be adjusted.

With the Late Night function, you can reduce the dynamic 
range of Dolby Digital material so that you can still hear 
quiet parts even when listening at low volume levels—
ideal for watching movies late at night when you don’t 
want to disturb anyone.

■

For Dolby Digital and Dolby Digital Plus sources, the 
options are:

`

Off:

Late Night function off.

`

Low:

Small reduction in dynamic range.

`

High:

Large reduction in dynamic range.

For Dolby TrueHD sources, the options are:

`

Auto:

The Late Night function is set to “On” or “Off” 
automatically.

`

Off:

Late Night function off.

`

On:

Late Night function on.

• The effect of the Late Night function depends on the material 

that you are playing and the intention of the original sound 
designer, and with some material there will be little or no effect 
when you select the different options.

• The Late Night function can be used only when the input source 

is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.

• The Late Night function is set to “Off” when the AV receiver is 

set to Standby. For Dolby TrueHD sources, it will be set to 
“Auto”.

After changing the settings of the “HDMI Control”, 
“Audio Return Ch”, “Power Control”, or “TV Con-
trol”, turn off the power to all connected pieces of 
equipment and then turn them on again. Refer to the 
User’s Manuals for all connected pieces of equipment.

1

2

q/w to select an item, and e/r to change the 

setting.
Repeat this step for the other settings.