Rosen dva410x 业主指南
410X
13
Installation and Wiring
1. Before Starting
Read these instructions and the following precautions
carefully.
carefully.
WARNING!
Be sure to disconnect the battery (-)
terminal before starting. This is to
prevent short circuits during installation.
terminal before starting. This is to
prevent short circuits during installation.
Precautions
•
This unit is exclusively for cars with a negative ground, 12V
power supply.
power supply.
•
Do not open the case. There are no user-serviceable parts inside.
If you drop anything into the unit during installation, consult your
dealer or an authorized Rosen service center.
If you drop anything into the unit during installation, consult your
dealer or an authorized Rosen service center.
•
Use a soft, dry cloth to clean the case. Never use a rough cloth,
thinner, benzene, alcohol, or other solvent. For tough dirt, apply a
small amount of cold or warm water to a soft cloth and gently
wipe.
thinner, benzene, alcohol, or other solvent. For tough dirt, apply a
small amount of cold or warm water to a soft cloth and gently
wipe.
2. Package Contents
•
410XR disc unit
•
IR Remote control
•
4-pin Power Supply harness
•
RCA Audio Cable
•
Additional IR Receiver (with cable)
•
Installation Brackets and Assorted Hardware
•
Owner’s Manual / Installation Guide
•
Warranty Card
3. Installation Requirements
1 Install the unit within 30 degrees of the horizontal plane.
Max. 30˚
2 Use the enclosed screws for installation. Using other
screws can cause damage and void the warranty.
Chassis
Chassis
Damage
Max. 8 mm (M5 screw)