Rosen em1 用户手册
1
2
3
4
3 Installing Your EM1
1.4 screws 10-32 x 1 Fhp 100 degree
2. # 10 washer ss 100 degree
3. Mounting baseplate
4. EM1 Main FPD Assembly
2. # 10 washer ss 100 degree
3. Mounting baseplate
4. EM1 Main FPD Assembly
Note :
Mounting plate is
only used when
you want to
surface mount
your EM1
Interface cable
Mounting plate is
only used when
you want to
surface mount
your EM1
Interface cable
Page 6
3 Installing Your EM1
C. Mounting on Wall to J-Box
• The EM1 is designed to mount in a round 3 1/2”
electrical junction box (J-Box) like the one
shown below.
shown below.
•
Make sure J-Box is secure before mounting
monitor assembly.
• Route 15ft interface cable from j-box to desired
Tuner module location.
• Use a 1/8” standard flat screw driver to remove
the base cover using the access notch as shown
below. When removing, be careful not to scar or
damage cover.
below. When removing, be careful not to scar or
damage cover.
Page 7
Note:
A J-box may be purchased at any local
hardware store
A J-box may be purchased at any local
hardware store
J-Box