Boundless adds 4000 用户指南
20 Installation
Connection A: Host DCE
1.
Enter the Setup menu. If the EIA port is to be assigned to Session 2, then switch
sessions (Ctrl-Enter (num)). Remain in session 1, if it is to be assigned to t hat
session.
sessions (Ctrl-Enter (num)). Remain in session 1, if it is to be assigned to t hat
session.
2.
In the Setup Quick (F1) menu, set the Host portion of the “Host/Printer”
selection to “EIA” without changing the current Printer option (“EIA/xxxx”).
The Printer will be set in another connection procedure if needed.
selection to “EIA” without changing the current Printer option (“EIA/xxxx”).
The Printer will be set in another connection procedure if needed.
3.
In the Ports (F6) menu, set the proper communications settings for the EIA
Baud, EIA Data Format, EIA Parity Check, EIA Recv, and EIA Xmt selections.
See the Setup chapter for more information on the individual settings.
Baud, EIA Data Format, EIA Parity Check, EIA Recv, and EIA Xmt selections.
See the Setup chapter for more information on the individual settings.
Connection B: Host DTE
1.
Enter the Setup menu. If the Aux p ort is to be assigned to Session 2, then switch
sessions (Ctrl-Enter (num)). Remain in session 1, if it is to be assigned to that
session.
sessions (Ctrl-Enter (num)). Remain in session 1, if it is to be assigned to that
session.
2.
In the Setup Quick (F1) menu, set the Host portion of the “Host/Printer”
selection to “Aux” without changing the current Printer option (“Aux/xxxx”).
The Printer will be set in another connection procedure if needed.
selection to “Aux” without changing the current Printer option (“Aux/xxxx”).
The Printer will be set in another connection procedure if needed.
3.
In the Ports (F6) menu, set the proper communications settings for the Aux
Baud, Aux Data Format, Aux Parity Check, Aux Recv, and Aux Xmt. See the
Setup chapter for more information on the individual settings.
Baud, Aux Data Format, Aux Parity Check, Aux Recv, and Aux Xmt. See the
Setup chapter for more information on the individual settings.
Connection C: RS-232 with Modem
1.
Follow all procedures of Connection A, steps 1 through 3.
2.
If you are connecting to a modem, set the “EIA Modem Control” parameter to
“On” in the Ports (F6) menu.
“On” in the Ports (F6) menu.
Connection D: RS-232-C with Modem
1.
Follow all procedures of Connection B, steps 1 through 3.
2.
If you are connecting to a modem, set the “Aux Modem Control” parameter to
“On” in the Ports (F6) menu.
“On” in the Ports (F6) menu.