Samsung ppm42h3 用户指南

Remove the screws from the back of the PDP.

Use the screws and assemble the plastic hanger.

☛

◆

Please ask the installers to install the wall mount bracket.

◆

Please be sure to check if the plastic hanger is completely secured on both the left and right
side after hanging the PDP on the wall mount bracket.

◆

Please avoid catching your fingers while installing and adjusting the angle.

◆

Please tightly secure the wall mount bracket to the wall to avoid injury from a falling PDP.

Tighten the screws of the plastic hanger to the back side of the PDP.

Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (

!

) to

secure it to the wall mount bracket (

@

). Tighten the screws as shown (

#

) so that the PDP cannot be

separated from wall mount bracket.

➢

The exterior of the PDP may be different than the picture.
(Assembly and installation of the plastic hanger is the same.)

PDP panel

Wall attachment panel bracket

Wall

0108 D55B-BN68-00589A-00_ENG  1/8/04  4:03 PM  Page 11