MrCoffee bvmc-pstx91 用户手册

Congratulations! You are the owner of a MR. COFFEE

®

 

water filtration system. This carbon-based water filter 

improves the taste of your coffee by removing up to 97% 

of the chlorine from the water you may use to brew your 

coffee.
To use the water filtration system in your MR. COFFEE

®

 

Coffeemaker, please follow these steps:
1.  Align the red indicator on the frame to the letter that 

corresponds with the month that you are using the disk 

for the first time. This serves to remind you to change 

the disk every month (approx. 30 brewing cycles).

NOTE: For optimum results, use the water filtration system 

with a permanent filter.
2. Rinse the water filter in fresh water before first use.
3. Follow Adding Water and Coffee instructions.
4.  When you are done brewing your coffee, rinse the 

water filter with fresh water. Do not put your water filter 

in the dishwasher.

To replace the water filter disks, twist the gray disk cover 

from your water filtration system. Remove the used disk. 

Insert the new disk into the frame and twist the cover back 

into place.

For best results, use a level tablespoon for ground coffee measurement.
Make sure you use medium grind coffee for a perfect brew.

 

10 Cups  

7.5 tbsp.

 

8 Cups  

6.5 tbsp.

 

6 Cups  

4.5 tbsp.

 

4 Cups  

3 tbsp.

1 level tablespoon (tbsp) = 5 gr./0.17 oz.
1 cup = 5 fl. oz. of brewed coffee
Use more or less coffee to suit your taste.

Red

Indicator

1.  Open the brew basket drawer (Figure 4). 
2.  Place a MR. COFFEE

®

 brand 10–12 cup paper basket-style 

filter or a MR. COFFEE

®

 permanent filter into the removable 

filter basket.

NOTE: If using paper filters, it is important that the sides of 

the filter fit flush against the side of the filter basket. If filter 

collapse occurs, dampen the filter before placing in the filter 

basket and adding ground coffee and water.
3.  Add the desired amount of coffee and gently shake to level 

the coffee. See the Suggested Coffee Measurement Chart 

(Figure 5).

4.  Slide the brew basket back into place (Figure 6).
5.  Fill the removable water reservoir  with cold, fresh water 

to the desired capacity (1 cup equals 5 ounces) For easy 

and accurate filling, the water markings on the removable 

water reservoir shows the amount of water needed to 

make the corresponding desired number of cups. Do not 

fill past the “10 cup MAX line” or water will flow out of the 

coffeemaker.

NOTE: The amount of coffee brewed will always be slightly 

less than the amount of water poured in the water reservoir. 

This is due to the minimum absorption of water by the coffee 

grounds.
NOTE: If the decanter is not in place then the coffeemaker 

will not brew. The BREW NOW LED will flash to signal that  

there is an error.

CAUTION:  

Do not place the decanter in the dishwasher.