Sony STR-DH710 用户指南

You can make various adjustments for HDMI 
settings.

x CTRL.HDMI

Lets you turn the Control for HDMI function 
on or off. For details, see ““BRAVIA” Sync 
Features” (page 55).

x PASS.THRU

Lets you output the HDMI signals to the TV 
even when the receiver is in standby mode. 
• ON

 

When the receiver is in the standby mode, 
the receiver continuously outputs HDMI 
signals from the receiver’s HDMI TV OUT 
jack.

• AUTO

 

When the TV is turned on while the receiver 
is in the standby mode, the receiver outputs 
HDMI signals from the receiver’s HDMI TV 
OUT jack. Sony recommends this setting if 
you use a TV that is compatible with 
“BRAVIA” Sync. This setting saves power 
in the standby mode compared with the 
“ON” setting.

• OFF

 

The receiver does not output HDMI signals 
when in the standby mode. Turn on the 
receiver to enjoy the connected component’s 
source on the TV. This setting saves power in 
the standby mode compared with the “ON” 
setting.

• This parameter is not available when 

“CTRL.HDMI” is set to “CTRL OFF”.

• When “AUTO” is selected, it may take a little more  

time for the image and sound to be output to the TV 
than when “ON” is selected.

• When the receiver is in standby mode, “HDMI” 

indicator will lights up if “PASS.THRU” is set to 
“AUTO” or “ON”. However, when “PASS.THRU” 
is set to “AUTO”, this indicator will lights off if no 
signals are detected. 

x AUDIO.OUT

Lets you set the HDMI audio output from the 
playback component connected to the receiver 
via an HDMI connection.

• TV+AMP

 

The sound is output from TV’s speaker and 
the speakers connected to the receiver.

• The sound quality of the playback component 

depends on the TV’s sound quality, such as the 
number of channels, and the sampling frequency, 
etc. When the TV has stereo speakers, the sound 
output from the receiver is also stereo as that of 
the TV, even if you play back multi channel 
software.

• When you connect the receiver to an image 

display component (projector, etc.), sound may 
not be output from the receiver. In this case, 
select “AMP”.

 

• AMP

 

The HDMI audio signals from the playback 
component are only output to the speakers 
connected to the receiver. Multi channel 
sound can be played back as it is.

Audio signals are not output from the TV’s 
speakers when “AUDIO.OUT” is set to “AMP”.

x SW LEVEL

Lets you set the level of the subwoofer to 0 dB 
or +10 dB when multi channel Linear PCM 
signals are input via an HDMI connection. You 
can set the level for each HDMI input 
independently.
• SW  AUTO

 

Automatically sets the level to 0 dB or 

 

+10 dB depending on the frequency.

• SW +10 dB
• SW 0 dB

This parameter is only available when HDMI input 
signals are detected.