Boss Audio bv7200 用户指南

BV7200 User’s Manual - page 3

A new disc may have rough edges on its 

inside and outside edges. If a disc with 
rough edges is used, the disc will not be 
properly seated and the player will not 
play the disc. Therefore, remove the rough 
edges in advance by using a ballpoint pen 
or pencil as shown on the right. Press the 
side of the pen or pencil against the inside 
and outside edges of the disc.

Notes:

- Choose a mounting location where the unit 

will not distract the driver.

- Before the installation of the unit, connect 

the wiring temporarily and make sure it is 
all connected properly and the unit and the 
system works.

- Use only the parts included with the unit 

to ensure proper installation. The use of 
unauthorized parts can cause malfunctions.

- Consult with your dealer if installation 

requires the drilling of holes or other 
modifi cations of the vehicle.

- Install the unit where it does not get in 

the driver’s way and cannot injure the 
passenger if there is a sudden stop, like an 
emergency stop.

- If installation angle exceeds 30° from 

horizontal, the unit may not perform 
properly.

- Avoid installing the unit where it will be 

subject to high temperature, such as from 
direct sunlight, or from hot air, from the 
heater, or where it would be subject to dust, 
dirt or excessive vibration. 

This unit can be installed either from the 
‘Front’ (conventional DIN Front-mount) or 

the ‘Rear’ (DIN Rear-mount installation 
using the threaded holes on the sides 
of the chassis). For details, refer to the 
following illustrated installation methods.

Remove transit screws before 
installation
Before installing the unit, please remove 
the two transit screws.