Infocus LP500 参考指南
12
S
e
t
t
i
n
g
u
p
t
h
e
P
r
o
j
e
c
t
o
r
Using the optional enhanced connectivity module
NOTE: If you have turned Auto
Source off (page 33), you may
need to press the source button on
the keypad more than once to
display an active source. The
sources switch in this order:
PC 1-Analog, PC 1-Digital,
PC 2-VESA, Video 3-Component,
Video 1 S-Video, and Video 2-
Composite.
This module connects to the projector via the projector’s com-
puter connector. Slide the tabs in the module into the grooves on
the back of the projector, then press the computer connector into
the projector. To remove the module, press down on the textured
lever on the top left of the module to release the latch, then slide
the module off.
puter connector. Slide the tabs in the module into the grooves on
the back of the projector, then press the computer connector into
the projector. To remove the module, press down on the textured
lever on the top left of the module to release the latch, then slide
the module off.
F
IGURE
11
Connecting the optional connectivity module to the projector
F
IGURE
12
Connector panel on optional enhanced connectivity module
S-video
composite
video
video
wired remote
computer 1-M1
computer 2-VESA
component
video
video
monitor
RS-232
audio in
(for all video sources)
(for all video sources)
computer
audio in
audio in
computer
audio in
audio in