ICOM IC-7000 说明手册
21
2
INSTALLATION AND CONNECTIONS
■
Linear amplifier connections
Use the
[ANT1]
connector when connecting an HF/50
MHz linear amplifier.
CONNECTING THE IC-PW1/EURO
To an
antenna
antenna
ACC-1
ANT
ANT1
ACC
INPUT1
REMOTE
EXCITER
1
1
1&2
GND
GND
IC-PW1/EURO
AC outlet
Non-European versions : 100–120/220–240 V
European version
European version
: 230 V
Ground
Transceiver
REMOTE
Remote control cable
(supplied with the IC-PW1/EURO)
ACC cable
(supplied with the IC-PW1/EURO)
Coaxial cable
(supplied with the IC-PW1/EURO)
7-pin side
OPC-599 conversion cable
(
)
CONNECTING A NON-ICOM LINEAR AMPLIFIER
R
WARNING:
• Set the transceiver output power and linear ampli-
fier ALC output level referring to the linear ampli-
fier instruction manual. Be sure the linear ampli-
fier keying circuit control voltage is compatible
with the IC-7000, before connecting to the
HSEND line (ACC cable).
fier instruction manual. Be sure the linear ampli-
fier keying circuit control voltage is compatible
with the IC-7000, before connecting to the
HSEND line (ACC cable).
• The ALC input level must be in the range 0 V to
–4 V, and the transceiver does not accept positive
voltage. Non-matched ALC and RF power settings
could cause a fire or damage the linear amplifier.
voltage. Non-matched ALC and RF power settings
could cause a fire or damage the linear amplifier.
• The IC-7000 SEND line (ACC connector pin 3) is
rate at 16 V/200 mA DC. If this level is exceeded,
a larger external relay must be used.
a larger external relay must be used.
HSEND
(Orange)
ALC (Blue)
13.8V (Gray)
Ground
GND
Relay
RF IN
RF OUT
ALC
KEY
ANT1
ACC cable
ACC
Transceiver
50
Ω
coaxial cable
To an
antenna
antenna