Pioneer VSX-D712 用户指南

下载
页码 72
Additional information
 10
69
En
Stereo Separation  . . . . . . . . . . . . . 40 dB (1 kHz)
Frequency Response . . . . . . . . . 30 Hz to 15 kHz 
(±1 dB)
Antenna Input (DIN)  . . . . . . . .75 Ω unbalanced
AM tuner section
Frequency Range. . . . . . . . 530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna). . . . . .  350 µV/m
Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . .  25 dB
Signal-to-Noise Ratio. . . . . . . . . . . . . . . . .  50 dB
Antenna  . . . . . . . . . . . . . . . . . . . . .Loop antenna
Miscellaneous
Power Requirements. . . . . . . . .  AC 120 V, 60Hz
Power Consumption
VSX-D812 . . . . . . . . . . . . . . . . . . .300W, 420 VA
VSX-D712 . . . . . . . . . . . . . . . . . . .260W, 340 VA
In standby  . . . . . . . . . . . . . . . . . . . . . . . .  0.5 W
AC Outlet  . . . . . . . . .  100 W MAX. (SWITCHED)
Dimensions  . . . 420 (W) x 158 (H) x 401 (D) mm
(16-9/16 (W) x 6-4/16 (H) x 15-6/16 (D) in.)
Weight (without package)
VSX-D812 . . . . . . . . . . . . . . . . . 10.5 kg (23.1 lb)
VSX-D712 . . . . . . . . . . . . . . . . . . 9.0 kg (19.8 lb)
Furnished parts
AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . .  1
FM wire antenna  . . . . . . . . . . . . . . . . . . . . . . . .  1
AA/R6 dry cell batteries 
. . . . . . . . . . . . . . . . .  2
Remote control  . . . . . . . . . . . . . . . . . . . . . . . . .  1
These operating instructions
. . . . . . . . . . . . .  1
• Specifications and the design are subject 
to possible modifications without notice, 
due to improvements.
*  Measured pursuant to the Federal Trade 
Commission’s Trade Regulation rule on Power 
Output Claims for Amplifiers.
**  Measured by Audio Spectrum Analyzer.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe 
off dust and dirt.
• When the surface is dirty, wipe with a soft 
cloth dipped in some neutral cleanser 
diluted five or six times with water, and 
wrung out well, and then wipe again with 
a dry cloth.  Do not use furniture wax or 
cleansers.
• Never use thinners, benzine, insecticide 
sprays or other chemicals on or near this 
unit, since these will corrode the surface.