Behringer GX108 用户指南
4
1. INTRODUCTION
1.2
Control elements
1.2.1 Front panel
Fig. 1.1: Front panel control elements
1
INPUT is the GX108’s 1/4" jack input for your guitar. Use a commercial
1/4" jack mono cable with good mechanical and electrical shielding.
1/4" jack mono cable with good mechanical and electrical shielding.
2
The GAIN control governs the degree of distortion produced by your GX108.
+
As high gain settings result in an output signal with plenty of treble
frequencies, it might be necessary to adapt the high-frequency range
with the TREBLE control.
frequencies, it might be necessary to adapt the high-frequency range
with the TREBLE control.
3
The LEVEL control determines the overall volume of the GX108.
4
The BASS control in the EQ section allows you to boost or cut the bass
frequencies.
frequencies.
5
With the MID control you can boost/cut the midrange frequencies.
6
The TREBLE control adjusts the upper frequency range.
7
Use the ON/OFF button to switch your GX108 on or off: the LED located
between the MID and TREBLE controls lights up when the unit is switched
on.
between the MID and TREBLE controls lights up when the unit is switched
on.
1.2.2 Rear panel
Fig. 1.2: Rear panel connectors