Cisco 3560x-24p 参考指南
B-8
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug cluster
debug cluster
Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
the no form of this command to disable debugging.
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| platform | snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | platform | snmp | vqpxy}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command is available only on the cluster command switch stack or cluster command switch.
The undebug cluster command is the same as the no debug cluster command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
discovery
Display cluster discovery debug messages.
events
Display cluster event debug messages.
extended
Display extended discovery debug messages.
hsrp
Display the Hot Standby Router Protocol (HSRP) debug messages.
http
Display Hypertext Transfer Protocol (HTTP) debug messages.
ip [packet]
Display IP or transport packet debug messages.
members
Display cluster member debug messages.
nat
Display Network Address Translation (NAT) debug messages.
neighbors
Display cluster neighbor debug messages.
platform
Display platform-specific cluster debug messages.
snmp
Display Simple Network Management Protocol (SNMP) debug messages.
vqpxy
Display VLAN Query Protocol (VQP) proxy debug messages.
Release
Modification
12.2(53)SE2
This command was introduced.