Cisco 3560x-24p 参考指南

下载
页码 1188
 
B-17
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B      Catalyst 3750-X and 3560-X Switch Debug Commands
debug ip dhcp snooping
debug ip dhcp snooping
Use the debug ip dhcp snooping privileged EXEC command to enable debugging of DHCP snooping. 
Use the no form of this command to disable debugging.
debug ip dhcp snooping {mac-address | agent | event | packet}
no debug ip dhcp snooping {mac-address | agent | event | packet}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug ip dhcp snooping command is the same as the no debug ip dhcp snooping command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable 
debugging on a stack member, you can start a session from the stack master by using the session 
switch-number privileged EXEC command. Then enter the debug command at the command-line 
prompt of the stack member. You also can use the remote command stack-member-number LINE 
privileged EXEC command on the stack master switch to enable debugging on a member switch without 
first starting a session.
Related Commands
mac-address
Display debug messages for a DHCP packet with the specified MAC address.
agent
Display debug messages for DHCP snooping agents.
event
Display debug messages for DHCP snooping events.
packet
Display debug messages for DHCP snooping.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are 
enabled.