Cisco 3560x-24p 参考指南
B-25
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug macsec
debug macsec
To enable debugging of 802.1ae Media Access Control Security (MACsec), use the debug macsec
privileged EXEC command. To disable debugging, use the no form of this command.
privileged EXEC command. To disable debugging, use the no form of this command.
debug macsec [errors | events]
no debug macsec [errors | events]
Syntax Description
Defaults
MACsec debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
Entering the debug macsec command with no keywords starts all MACsec debugging facilities.
The undebug macsec command is the same as the no debug macsec command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without starting a session.
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without starting a session.
Related Commands
errors
(Optional) Displays MACsec error debugging messages.
events
(Optional) Displays MACsec event debugging messages.
Release
Modification
12.2(53)SE2
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.