GoVideo t2040 用户手册

下载
页码 22
4
•  When relocating the product placed on a cart, it 
must be moved with utmost care. Sudden stops, 
excessive force and uneven floor surface can 
cause the product to fall from the cart. 
•  Ventilation - The vents and other openings in 
the cabinet are designed for ventilation. Do not 
cover or block these vents and openings since 
insufficient ventilation can cause overheating and / 
or shorten the life of the product. Do not place the 
product on a bed, sofa, rug or other similar surface 
since they can block ventilation openings. This 
product is not designed for built-in installation; do 
not place the product in an enclosed place such 
as a bookcase or rack, unless proper ventilation 
is provided or the manufacturer’s instructions are 
followed.
•  The LCD panel used in this product is made of 
glass. Therefore, it can break when the product is 
dropped or applied with impact. Be careful not to 
be injured by broken glass pieces in case the LCD 
panel breaks.
•  Heat sources - Keep the product away from 
heat sources such as radiators, heaters, stoves 
and other heat - generating products (including 
amplifiers).
•  The LCD panel is a very high technology product 
with many thin-film-transistors, giving you fine 
picture details. Occasionally, a few non-active 
pixels may appear on the screen as a fixed point 
of blue, green or red. Please note that this does 
not affect the performance of your product.
•  If an outside antenna is connected to the 
television equipment, be sure the antenna system 
is grounded so as to provide enough protection 
against voltage surges and built-up static 
charges. Section 810 of the National Electrical 
Code provides information with respect to proper 
grounding of the mast and supporting structure, 
grounding of the lead-in wire to an antenna 
discharge unit, size of grounding conductors, 
location of antenna-discharge unit, connection to 
grounding electrodes, and requirements for the 
grounding electrode.
•  For added protection to this television equipment 
during a lightning storm, or when it is left 
unattended and unused for long periods of time, 
unplug it from the wall outlet and disconnect 
the antenna. This will prevent damage to the 
equipment due to lightning and power-line surges.
•  An outside antenna system should not be located 
in the vicinity of overhead power lines or other 
electric light or power circuits, or where it can fall 
into such power lines or circuits. When installing 
an outside antenna system, extreme care should 
be taken to keep from touching such power lines 
or circuits as contact with them might be fatal.
•  Read instructions - All operating instructions must 
be read and understood before the product is 
operated.
•  Keep this manual in a safe place - These safety 
and operating instructions must be kept in a safe 
place for future reference.
•  Observe warnings - All warnings on the product 
and in the instructions must be observed closely
•  Follow instructions - All operating instructions must 
be followed.
•  Attachments - Do not use attachments that are 
not recommended by the manufacturer. Use of 
inadequate attachments can result in accidents.
•  Entering of objects and liquids - Never insert an 
object into the product through vents or openings. 
High voltage exists in the product, inserting an 
object can cause electric shock and / or short 
internal parts.
  For the same reason, do not spill water or liquid 
on the product.
•  Servicing - Do not attempt to service the product 
by yourself. Removing covers can expose you 
to high voltage and other dangerous conditions. 
Request a qualified service person to perform 
servicing.
•  Repair - If any of the following conditions. unplug 
the power cord from the AC outlet, and request a 
qualified service person to perform repairs
a.  When a liquid was spilled on the product or 
when objects have fallen into the product.
b.  When the product has been exposed to rain or 
water.
•  Cleaning - Unplug the power cord from the Ac 
outlet before cleaning the product. Use a damp 
cloth to clean the product. Do not use liquid 
cleaners or aerosol cleaners.
•  Water and moisture - Do not use the product 
near water, such as bathtub, washbasin, kitchen 
sink and laundry tub, swimming pool and in a wet 
basement.
•  Stand - Do not place the product on an unstable 
cart, stand, tripod or table. Placing the product 
on an unstable base can cause the product 
to fall, resulting in serious personal injuries as 
well as damage to the product. Use only a cart, 
stand,tripod, bracket or table recommended 
by the manufacturer or sold with the product. 
When mounting the 
product on a wall, be sure 
to follow the manufacturer’s 
instructions. Use only 
the mounting hardware 
recommended by the 
manufacturer.
Important Safety Instructions