Numatic hvr200m 用户指南

Read the instruction manual before using the machine.

Operators shall be adequately instructed on the use of thier machine.

As with all electrical equipment, care and attention must be exercised at all times during use, in 

addition to ensuring that routine and preventative maintenance is carried out periodically to ensure 

safe operation. 

Failure to carry out maintenance as necessary, including the replacement of parts to the correct 

standard could render this equipment unsafe and the manufacturer can accept no responsibility in 

this respect. Maintenance should only be carried out by a qualified person.

This machine is for DRY USE only and must not be stored outside or used in wet conditions.

The machine shall be disconnected from the mains by removing the plug from the supply socket 

during cleaning or maintenance and when replacing parts or converting the machine to another 

function.

The machine is not to be used by children or persons with reduced physical, sensory or mental 

capabilities, or lack of experience or knowledge, unless they have been given supervision or 

instruction.

This appliance is intended to be cleaned and maintained by an adult.

Children being supervised are not to play with the machine.

This machine is not a toy.

This machine is not suitable for picking up hazardous or explosive dust. Contact your local 

distributor if you require a machine capable of performing these tasks. 

Ensure that the filtration system fitted to the machine is suitable for the material being collected.

This vacuum cleaner is intended for indoor use in the collection of dry materials.

This machine should be stored indoors only. 

This machine is also suitable for commercial dry use, for example in hotels, schools, hospitals, 

factories, shops and offices for other than normal housekeeping purposes.

This product complies with the requirements of clause 20 of EN 60335-2.69 Stability and 

Mechanical Hazards.

This vacuum cleaner is fitted with a thermal protection device. If the vacuum cleaner stops work-

ing, remove the plug from the wall before investigating where the fault lies.

If the vacuum cleaner has a blockage, switch off, remove the plug from the wall, inspect the floor 

tool, tubes and hose for debris. If the floor tool, tubes and hose are clear, replace the dust bag and 

clean the filter.

The vacuum cleaner should be inspected after use for damage.

Not suitable for the collection of biological hazards, hazardous, or explosive dusts .

The vacuum cleaner should be stored in a dry place.

Page 3