Sound Storm s1002 用户指南

Troubleshooting

Before removing your amplifier, refer to the list below and follow the
suggested procedures, Always test the speakers and their wires first.

No Output

Confirm that all terminal strip connections are secure and tonight.

Check both in-line and built-in fuses. Both the "+12v" and the "REMOTE" terminals must
have +12v referenced to chassis ground.

Confirm that the audio signal source (car audio, equalizer, etc.) is connected and is
supplying output signal. To check if the amplifier is supplying signal, unplug the RCA
cables from the signal source (but leave them plugged into the amp). Briefly tap the
center pin of each of the disconnected RCA plugs with your finger. this should produce
a noise (feedback) in your speakers.

Only one
channel
works

Confirm that all speaker strip connections are secure and tonight.

Check the "BALANCE" control on the head unit (or other source) to verify that it is
set to its midpoint.

If you are using the Low Level RCA input, reverse the input plugs at the amplifier (switch
the R with the L). If the channel which is silent switches to the other side, the problem
is either in the head unit/other source or the connecting cables.

Weak output

Readjust the input Sensitivity control to better suit the input signal.

Noise in the

If the noise is a "whine" whose

Audio

pitch follows the engine speed, confirm that the amplifier

and any other signal sources (head unit ,etc.) are properly grounded.

If the noise is a "clicking"or "popping" noise whose rate follows the engine speed, this
usually means that the vehicle is equipped with resistor spark plugs and wires, or that
the ignitions is in need of service.

Check the routing

of the speakers and input wires to make sure they are not adjacent

to wires which interconnect lights and other accessories.

If the above steps fail to improve or clear noise interference, the system should be
checked by a professional mobile audio installer.