Soundstream 1002 用户手册
INSTALLATION STEP 3
WIRING
POWER
AND
GROUND
To ensure maximum output from your
amplifier,
use
high quality, low-
power and ground cables and connections. The
amplifiers will
accept up to 4 gauge power and ground cables. Determine from the chart below
the minimum gauge power and ground wire for your application.
the minimum gauge power and ground wire for your application.
REMOTE TURN-ON
Connect the “Remote” line to the turn-on lead from the source unit. When
Volts is received, the amplifier will turn on.
Volts is received, the amplifier will turn on.
Use a high quality cable that will be easy to install and has minimal signal loss
guarantee optimum performance.
guarantee optimum performance.
The
amplifiers will accept up to 8 gauge speaker cable. Use a high
quality, flexible, multi-strand cable for best performance and longevity.
RUB/CON Amplifier Fuse Values
SIGNAL CABLE
502
4 or 8 gauge
4 gauge only
RUB/CON 702
4 or 8 gauge
4 gauge only
RUB/CON 1002
4 gauge only
4 gauge only
Amplifier Fuse
I
Battery Fuse Circuit Breaker
502
(2) 30
amp
automotive
80 amp
RUB/CON 702
60 amp Maxi-fuse
80 amp
SPEAKER CABLE
CIRCUIT BREAKERS AND FUSES
EXTERNAL
Like all audio components, the
Like all audio components, the
amplifiers must be fused near the
battery. A fuse or circuit breaker must be located within 18” of the
This will
at the
prevent a fire in the event of a shorted cable. See the chart below to determine the
Battery
correct fuse value.
INTERNAL
The
The
amplifiers are fused with an automotive-type or Maxi-fuse. In the
event of a blown power supply fuse(s), replace with the correct value fuse found in
the chart below. Never replace the fuse with a higher value than what is sup-
plied. This may result in amplifier damage and will void the warranty1
Battery
Terminal
Terminal
To Chassis
Ground
Ground
To 2nd
Amplifier
SPEAKERS
[Head Unit
RUB/CON 1002
80 amp Maxi-fuse
100
a m p
14
15