SpeakerCraft aim wide five 用户指南
SPEAKER ADJUSTMENT
Adjusting the Aim Wide Mechanism
The woofer and dual mid-tweeter module can be pivoted to best direct the sound towards the listener. They easily rotate
and pivot to almost any position desired. Simply apply pressure with fingertips to the outer surface of the PivotBall and move
the speaker to the desired position (See Figure 4).
DO NOT adjust by pushing on
the Dual Mid-Tweeter Module
the Dual Mid-Tweeter Module
Figure 4
Adjust direction by pushing the
outer surface of the PivotBall
outer surface of the PivotBall
PAINTING THE SPEAKERS
If you plan to paint your speakers, we recommend that it be done prior to installation. If you decide to paint your speakers
sometime in the future, it is best to remove them by simply reversing the steps for SPEAKER INSTALLATION listed above. When
painting the speakers, the paint masks provided in the carton must be installed in place of the grille. The grilles can also
be painted. However, great care should be taken not to clog the holes, as this will greatly reduce the sound quality of the
speakers. Before painting the grilles, remove the material under grille. Place this material back in place once the grille has
been painted. SpeakerCraft recommends only light spray painting using 5 parts thinning agent to 1 part paint. Do not paint
the grilles while they are attached to the speaker. If it is necessary to paint the material under the grille, follow the same
procedure used to paint the grilles.
4
PRINTING INSTRUCTIONS: AIM WIDE MANUAL - INK: BLACK (1 over 1) MATERIAL: 80lb Gloss - SIZE: 11" x 17" folded to 8.5” x 11”
PRINTING INSTRUCTIONS: AIM WIDE MANUAL - INK: BLACK (1 over 1) MATERIAL: 80lb Gloss - SIZE: 11" x 17" folded to 8.5” x 11”