jWIN jx-cd7100 用户指南
10
NOTES:
If the PLAY/PAUSE Button is pressed before the Memory/Program Button is pressed to store a
track, the track will not be programmed, and the disc will start playing from the first selected track.
Any track can be programmed to play more than one.
track, the track will not be programmed, and the disc will start playing from the first selected track.
Any track can be programmed to play more than one.
Repeatedly pressing the Memory/Program button will enable you to check the Program if required.
LISTENING TO PROGRAMMED TRACKS
1.
Enter all tracks you want to program into memory following the procedure above.
2.
Press the PLAY/PAUSE Button.
3.
Disc play will start at the beginning of the first Programmed track.
TO CLEAR THE PROGRAM MEMORY
If the disc is playing, press the STOP Button. The word MEMORY will disappear.
The Program memory will also be cleared if the disc compartment is opened, if the function is
changed, or if the power is switched off.
changed, or if the power is switched off.
SLEEP FUNCTION
When the disc is playing, press the SLEEP button. The word SLEEP will flash and 90 (minutes) will
appear. Press SLEEP repeatedly to select the time you want (max 90, min 10). Then the unit will
resume playing mode, but SLEEP will display on the screen. The unit will change to standby mode at
the preset time. For example, if you select 10 minutes, the unit will go into standby after 10 minutes.
To cancel the sleep function, press the sleep button again. The sleep indicator will disappear.
appear. Press SLEEP repeatedly to select the time you want (max 90, min 10). Then the unit will
resume playing mode, but SLEEP will display on the screen. The unit will change to standby mode at
the preset time. For example, if you select 10 minutes, the unit will go into standby after 10 minutes.
To cancel the sleep function, press the sleep button again. The sleep indicator will disappear.
TIME FUNCTION
This function can make the unit automatically run at the press time and can be used from standby
mode. Press Memory/Program button about 3 seconds. The time system will flash. Press Tuning/
Search Forward or REW button press your desired time systems and press Memory Down/Program
button again,(12h or 24h) then the hours will flash. Press Tuning/Search Forward or REW button
press your desired hours. Press Memory/Program button to confirm. Then the minutes will flash.
Press Tuning/Search Forward or REW button preset your desired minutes. Press Memory/Program
button to confirm.
mode. Press Memory/Program button about 3 seconds. The time system will flash. Press Tuning/
Search Forward or REW button press your desired time systems and press Memory Down/Program
button again,(12h or 24h) then the hours will flash. Press Tuning/Search Forward or REW button
press your desired hours. Press Memory/Program button to confirm. Then the minutes will flash.
Press Tuning/Search Forward or REW button preset your desired minutes. Press Memory/Program
button to confirm.
TIMER SETTING
The timer function allows you to set an automatic switch-on and switch-off time. To do so the time
must be set correctly.
must be set correctly.
SET TIMER ON
1.
Switch the unit to Standby mode by pressing the POWER button and the Standby LED on the
unit should light up.
unit should light up.
2.
Press the TIMER button on the remote control, TIMER will flash on the display.
3.
Press the MEMORY/CLOCK button on the remote control about 3 seconds then release the
hour digits start to flash in the display, use the SKIP Up/Down buttons to set the hours
required.
hour digits start to flash in the display, use the SKIP Up/Down buttons to set the hours
required.