LG HB6422A 业主指南

Make sure that the voltage and capacity of the power line conform
to the data shown on the plate located under the casing. Do not
remove this plate for any reason.
The plug on the end of the supply cable and the wall socket must
be the same type and conform to the current electrical system
regulations. Check that the power line is adequately grounded.
On the power line, install an omnipolar cut-off device with contact
cut-off distance greater than or equal to 3 mm, located in an easily
accessible position near the unit.
Do not use reducers, adapters or shunts.

If the power cable is replaced, the wire section on the new cable
must not be less than 1.5 mm

2 

(3 x 1.5 cable), keeping in mind

that the end to be connected to the hob must have the ground
wire (yellow-green) longer by at least 20 mm. Use only
H05V2V2-F cable or similar which has a maximum temperature
of 90°C. Any replacement needed should be carried out by a
specialised technician who should make the mains connections
according to the following diagram.
L = brown
N = blue

= yellow-green

The manufacturer will not be liable for any damage to
persons or property caused by non-observance of the above
instructions or deriving from the tampering of even a single part
of the hob.