GFI MailSecuriti Suite, 250-499u, 3Y, SMA RNW MSECMCREN250-499-3Y 用户手册
产品代码
MSECMCREN250-499-3Y
Appendix - Installing on a Microsoft Exchange 2003 cluster
GFI MailSecurity 2011
47
13 Appendix - Installing on a Microsoft Exchange 2003
cluster
A Microsoft Exchange cluster can be set up in one of 2 modes: active/active or active/passive. This
appendix describes how to install GFI MailSecurity on a Microsoft Exchange 2003 Active/Passive
cluster
appendix describes how to install GFI MailSecurity on a Microsoft Exchange 2003 Active/Passive
cluster
NOTE: Installing GFI MailSecurity on a Microsoft Exchange 2003 Active/Active cluster is currently
not supported.
not supported.
NOTE: Installing GFI MailSecurity on a Microsoft Exchange Server 2007 cluster environment is
currently not supported.
currently not supported.
Although you can install GFI MailSecurity on an Active/Passive cluster, you still need to configure
and manage a GFI MailSecurity installation per node. The configuration settings and quarantine
emails are not shared between nodes.
and manage a GFI MailSecurity installation per node. The configuration settings and quarantine
emails are not shared between nodes.
The following steps are required on each node:
Install GFI MailSecurity on the node local hard drive.
NOTE: Do not install GFI MailSecurity on the shared drive.
Install the GFI MailSecurity WWW virtual directory
on the node‟s Default Web Site.
If you are installing on an IIS cluster, make sure you bind GFI MailSecurity to the Clustered
SMTP Virtual Server instance.
The following steps show you how to install GFI MailSecurity in a typical Active/Passive Cluster
environment. For this scenario, assume the cluster, named MAILCLUSTER, is made up of two
nodes, named Node1 and Node2.
environment. For this scenario, assume the cluster, named MAILCLUSTER, is made up of two
nodes, named Node1 and Node2.
1. Using the Cluster Administrator console make Node1 active.
2. Install GFI MailSecurity on the local hard drive of Node2
as described in the „Installing GFI
MailSecurity‟ section of this chapter. When you reach the IIS Setup step of the installation, select
Default Web Site to host the GFI MailSecurity WWW virtual directory.
Default Web Site to host the GFI MailSecurity WWW virtual directory.
NOTE: The Default Web Site IP address of Node2 should be set to use the IP address of the
MAILCLUSTER machine.
MAILCLUSTER machine.
3. When the GFI MailSecurity installation on Node2 completes, you should be able to access the
Node2 configuration using the following URL: http://Node2/MailSecurity/
Node2 configuration using the following URL: http://Node2/MailSecurity/
4. From the Cluster Administrator console, make Node2 active.
5. Install GFI MailSecurity on the local hard disk of Node1
as described in the „Installing GFI
MailSecurity‟ section of this chapter. When you reach the IIS Setup step of the installation, select
Default Web Site to host the GFI MailSecurity WWW virtual directory.
Default Web Site to host the GFI MailSecurity WWW virtual directory.
NOTE: The Default Web Site IP address of Node1 should be set to the IP address of the
MAILCLUSTER machine.
MAILCLUSTER machine.
6. When the GFI MailSecurity installation on Node1 completes, you should be able to access the
Node1 configuration using the following URL: http://Node1/MailSecurity/
Node1 configuration using the following URL: http://Node1/MailSecurity/
7. To access the product configuration of the currently active node use the following URL:
http://MAILCLUSTER/MailSecurity/.
http://MAILCLUSTER/MailSecurity/.