Sony LF-B1 手册

16

z 

• The NETAV LED continues to blink for about 

one minute before turning off. 

• If the NETAV LED turns on amber, check that 

the router and modem are turned on and the 
network cable is connected properly. 

• When the NETAV LED turns green, another 

device is connected by NetAV. Wait until the 
LED turns off to perform this step.

• NetAV cannot be used via a proxy server.

The setup is complete if [Success] appears in 
the [NetAV Check] screen. 
If the test page does not appear, check the 
network connection. 

The display returns to the initial screen. 
After selecting [Exit Setup] and pressing the 

 button, close the browser by pressing the 

 button.

Read the instructions on the NetAV Check screen 
and configure the necessary settings. 

The Base Station needs to be set up to use the 
NetAV function away from home. There are two 
setup types: [Easy Setup] and [Advanced Setup]. 
[Easy Setup] requires the router to be UPnP 
(Universal Plug and Play) compatible and the 
UPnP function of the router to be enabled. Refer 
to the instructions supplied with your router and 
confirm the settings. 

If your router is not UPnP compatible, you prefer 
not to use the UPnP function of the router, or if 
you tried to use the UPnP function but the setup 
was unsuccessful, port forwarding needs to be set 
on the router.
The settings for port forwarding may vary 
depending on the router in use. For details, refer 
to the instructions supplied with your router.

z 

• Port forwarding is a function that allows network 

communications with your router to be forwarded 
directly to your network device (such as a PC or a 
PSP™ system). It may also be called "Port 
Mapping", "Address Change" or other names. To 
connect to the LocationFree Base Station from 
outside your home using port forwarding, you must 
adjust the settings for the router to allow the data 
connection received by the router over the Internet to 
get through to the Base Station port (initial setting: 
5021).

• It is necessary to set the Base Station’s IP address to 

activate the port forwarding setting on the router. For 
details, refer to the instructions supplied with your 
router and "Setting up a router incompatible with the 
UPnP function" (

• Some UPnP-compatible routers are only compatible 

with specific messenger services and games. For 
such a router, set port forwarding.