Sony XDP-PK1000 手册

11

Tip for setting the SW LOCATION switch
If you are not sure about these sound 
settings, set the VEHICLE SIZE switch first, 
and then set the SW LOCATION switch to 
where bass sound appears to come from in 
front of the driver’s seat.

You can adjust the sound balance easily by 
using the supplied remote commander 
(page 7).
The system allows you to make separate 
settings for each source (car audio unit, 
iPod and iPhone)*. The setting you make 
for a source is applied each time that source 
is selected.
*The ALO button works only for an iPod/

iPhone selected as the source.

• Turn off the EQ of your iPod/iPhone before 

adjusting the following sound settings.

Press the FRONT/REAR/LEFT/RIGHT 
buttons to adjust the balance between 
the speakers.
An adjustment range of 7 steps is available 
for each speaker setting. Press and hold the 
CNT button to return to the default setting. 
The default setting is CNT (center). 

Press the TREBLE (–/CNT/+) button.
Available settings are -7 to +7, in 1-step 
increments. Press and hold the CNT button 
to return to the default setting. The default 
setting is 0.

Press the BASS (–/CNT/+) button.
Available settings are -7 to +7, in 1-step 
increments. Press and hold the CNT button 
to return to the default setting. The default 
setting is 0.

Press the SUB VOL +/– button.
Available settings are from -7 (no sound) to 
+6, in 1-step increments. The default setting 
is 0.

Press the ALO button.
Adjust the playback volume level of an 
iPod/iPhone to the optimum level.
Press the ALO button repeatedly to switch 
between ON and OFF. The default setting is 
ON. This function is available only when an 
iPod/iPhone is selected as the source.
• ON: A high-pitched beep
• OFF: A low-pitched beep

FAR

MID

NEAR