Sony XMG-S4 手册

下载
页码 156
6
GB
 Use a power supply wire with a fuse (60 A) 
attached. 
 All power wires connected to the positive battery 
post should be fused within 450 mm (17 
3
/
4
 in) of 
the battery post, and before they pass through 
any metal.
 Make sure that the car’s battery wires connected 
to the car (ground (earth) to chassis) are of a wire 
gauge at least equal to that of the main power 
wire connected from the battery to the amplifier. 
 During full-power operation, a current of more 
than 60 A will run through the system. Therefore, 
make sure that the wires to be connected to the 
+12 V and GND terminals of this unit are at least 8-
Gauge (AWG-8) or have a sectional area of more 
than 8 mm² (
11
/
32
 in²).
Making power connections
Power connection wires (not supplied) are required.
*1 If you have the factory original or some other car 
audio unit without a remote output for the amplifier, 
connect the remote input (REM) terminal to the 
accessory power supply. In High level input 
connection, the car audio unit can also be activated 
without need for REMOTE connection. However, this 
function is not guaranteed for all car audio units.
*2 Ground (earth) to chassis.
 Line input connection
With the speaker connection 
, ,  or  
Note
You can enjoy high-resolution sound when this unit is 
connected to a high-resolution audio supported car 
audio unit (e.g. RSX-GS9).
 Line input connection
With the speaker connection 
 (page 8)
Note
You can enjoy high-resolution sound when this unit is 
connected to a high-resolution audio supported car 
audio unit (e.g. RSX-GS9).
Fuse (60 A)
+12 V car battery
less than 450 mm (17 
3
/
4
 in)
to a metal point of the car
Input Connections
Front
Rear
Left
Right