KitchenAid 30" Combination Wall Oven with Even-Heat™ True Convection (Lower Oven) 安装指导
4
INSTALLATION INSTRUCTIONS
Prepare Built-In Microwave/Oven
Combination
NOTES:
■
Refer to the following “Installation Instructions” and the
“Installation Instructions” section of the Installation
Instructions provided with your built-in microwave/oven
combination.
“Installation Instructions” section of the Installation
Instructions provided with your built-in microwave/oven
combination.
■
Refer and adhere to the “Electrical Requirements” section and
complete the instructions in the “Make Electrical Connection”
section of the Installation Instructions provided with your built-
in microwave/oven combination.
complete the instructions in the “Make Electrical Connection”
section of the Installation Instructions provided with your built-
in microwave/oven combination.
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
2. To avoid floor damage, set the oven on cardboard prior to
installation. Do not use the handle or any portion of the front
frame for lifting.
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials that
may be needed for installation.
may be needed for installation.
4. Remove the hardware package from inside the bag containing
literature.
5. Move the oven and cardboard close to the oven’s final
location.
Remove Oven Door
IMPORTANT: Use two hands to remove the oven door.
1. Prior to removing the oven door, prepare a surface where you
1. Prior to removing the oven door, prepare a surface where you
will place it. This surface should be flat and covered with a soft
blanket, or use the corner posts from your packaging material.
blanket, or use the corner posts from your packaging material.
2. Open the oven door.
3. Locate the oven door hinge locks in both corners of the oven
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
4. Partially close the door to engage the door latch locks. The
door will stop at this point.
5. Using two hands, grasp the edges of the oven door. Lift and
pull the oven door toward you and remove it. You may need to
gently shift the door from side to side as you pull.
gently shift the door from side to side as you pull.
6. Set the oven door aside on the prepared covered work
surface, with the oven door resting on its handle.
7. To continue with the oven installation, go to the “Positioning
Oven Feet” section.
Replace Oven Door
1. Using two hands, grasp the side edges of the door at the
midpoint. Face the oven cavity.
2. Locate the slots on each side of the oven cavity for the door
hinge locks.
A. Oven door hinge lock in
locked position
B. Oven door hinge lock in
partially unlocked position
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
A
B
A. Slot in the oven cavity for door hinge lock
A