Canon MP27-MG 用户手册

Este conmutador activa la cuenta e impresión del número de ítems hasta 999.

Cuando el contador de n de entradas está situado en n+, la calculadora 

contará el n de veces que las teclas  +  y  –  se presionan. Cuando el 

contador de n de entradas está situado en n+/– la calculadora contará el n de 

veces que se presiona la tecla  +  y restará del total el n de veces que se 

presiona la tecla  –  .

Cuando el contador de n de entradas está situado en n+, la calculadora 

contará el n de veces que las teclas       y       se presionan. Cuando el 

contador de n de entradas está situado en n+/– la calculadora contará el n de 

veces que se presiona la tecla       y restará del total el n de veces que se 

presiona la tecla       .

Cuando el interruptor de impresión “PRINT” se posiciona en ON, y el interruptor 

de cuenta de entradas (ITEM) está en la posición n+ o n+/–, puede imprimirse 

el número de entradas registradas por el contador, hasta tres dígitos, en la 

izquierda del papel, presionando la tecla       o la tecla       para la cuenta de 

entradas y la tecla       o la tecla      para la memoria de cuenta de entradas.

Cuando el poder está en "ON" y la calculadora no se utiliza durante aprox.

7 minutos. La calculadora cambiará al modo ahorro de energía automáticamente

con la luz LED naranja. Pulse       la calculadora volverá al modo de

cálculo normal.

 

–  Used for designating the decimal point position (+ 0 2 3 4 6 F) 

 

    for calculated results.
+ (Add-Mode) – Addition and subtraction functions are performed with 

an automatic 2-digit decimal. It is convenient for currency calculations.
F (Floating Decimal Point) – All effective numbers up to 12 digits are 

printed or displayed.

PRINTED IN CHINA

INSTRUCTIONS

INSTRUCCIONES

   REPLACING BACKUP BATTERY

Memory backup battery retains the tax rate, calendar and clock setting, when the  

power is off or even when the AC cord is disconnected.

Battery : 1 Lithium battery (Type : CR2032)

Battery life : Backup time 2000 hours

CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of

                  used batteries according to the instruction.

 

Note: Turn the power off.

1) Remove the cover and lift up the paper arm.

2) Lift ribbon spools off the shafts. Discard the old ribbon and spools.

3) Place the ribbon spool on the left spool pin and push it down until it clicks.

4) Thread the ribbon along the outer edge of the side guide, making sure 

that the black half of the ribbon is still on the top.

5) Place the ribbon between the printing ring and printing roller. Thread the 

ribbon along the outer edge of the left side guide.

6) Place the other ribbon spool on another spool pin.

7) Push the spool down until it clicks.

8) Take up any ribbon slack by rotating the left spool counterclockwise.

9) Replace the printer cover.

– Used for round-up [     ] , round-off [5/4], or round-down  [     ]to the 

pre-selected decimal digits in the result.

 

– When the calculations are performed with the GT switch set to "ON", 

the total(s) are accumulated in the grand total memory. Each time      

is pressed, the subtotal number is printed with the symbols G+. 

 

  When      is pressed, the intermediate grand total is printed with the 

symbols G    . Press      successively to get the grand total followed by 

the symbols G   .

 

– Set switch to "TAX RATE SET" for setting or recalling the TAX rate.

In the following cases, when "E" is displayed, "ERR" is printed, the keyboard is 

electronically locked, and further operation is impossible. 

Press       to clear the overflow. The overflow occurs when:

1.  The result or the memory content exceeds 12 digits to the left of the decimal point.

2.  Dividing by "0".

3.  The sequential operation speed is faster than the calculation processing speed. 

(Buffer Register Overflow)
Electromagnetic interference or electrostatic discharge may cause the display to 

malfunction or the memory, currency rate and tax rate to be lost or 

altered. Should this occur, use the tip of a ballpoint pen 

(or similar sharp object) to press the [RESET] button on 

the back of the calculator. After resetting be sure to set

the calendar, clock and tax rate again.

Power Source: AC120V, 60Hz

Operation Temperature: 0°C to 40°C (32°F to 104°F)

Calculating Capacity: 12 digits maximum                                           

Dimension:  320mm (L) x 193 mm (W) x 71mm (H) / 

 

12-39/64" (L) x 7-39/64" (W) x 2-51/64" (H)

Weight: 1,812 g (4 lbs)

Included battery contains perchlorate material - special handling may apply.

See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ for detail.

The bottom case and printer cover in this product are made from recycled Canon 

copier plastic.

“ERR”

La batería incluida contiene el material del perclorato - El manejo especial debe ser aplicado. 

Para el detalle, por favor ver http://www.dtsc.ca.gov/hazardouswaste/perchlorate

 

AC120V, 60Hz

Peso: 1,812 g (4 lbs)

320mm (An) x 193 mm (Pr) x 71mm (Al) / 

12-39/64" (An) x 7-39/64" (Pr) x 2-51/64" (Al)

When the power is turned "ON" and the calculator is not being used for approx. 7 

minutes. The calculator will switch to power save mode automatically with orange 

LED light-up. Press       key the calculator will return to normal calculation mode.

At "n+" or "n+/–" position, the calculator counts and print the number of 

calculation items up to 999.

When the "ITEM" switch is set at "n+", the calculator counts the number of 

times the  +  and  –  keys are pressed.

When the switch is set at "n+/–", the calculator counts the number of times the   

 +  key is pressed and subtracts from the total numbers of times the  –  key is 

pressed.

When the "ITEM" switch is set at "n+", the calculator counts number of 

times        and        keys are pressed.

When the switch is set at "n+/–", the calculator counts the number of times 

the       key is pressed and subtracts from the total number of times the       key 

is pressed.

When the PRINT switch is turned "ON", and the "ITEM" switch is at the "n+" or 

"n+/–" position, the number of items recorded by the counter can print up to 

three digits on the left-hand side of the paper by pressing either the      key or 

the       key for item count and       key or       key for memory item count.

Print Off – Entries and results will appear on the display, but will not be 

printed out.
Print On – Entries and results will appear on the display and will be 

printed out.

1)  Remove the insulation tape at the back of calculator. (Figure      )

2)  Remove the tape on the ink ribbon of calculator. (Figure     ,     )

3)  Plug in AC power cord. (Figure     )

4)  Turn the power switch on. (Figure     )

5)  Press [RESET] key before use. (Figure     )

a

b c

d

e

f

e

f

b

c

a

d

Note : Turn the power off

1) Remove the printer cover (Figure      ) and lift up the paper arm (Figure      ).

2) Replace the printer cover (Figure      ).

  • When inserting the paper, cut the edge of the paper as shown (Figure      ).

3) Turn the power switch on (Figure      ).

4) Place the new paper roll on the arm. The edge of the paper should be 

positioned as shown (Figure      ).

  • Suitable paper roll -- Width : 57mm (2-1/4”) / Diameter: 86mm (3-3/8”)

5) Press the paper feed key        to advance the paper (Figure      ).

e

f

b

c

a

d

E-IM-2474