Canon REALiS SX7 Mark II D 说明手册

122

MAINT

ENANCE

When the time of use of the lamp exceeds the certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.

z If the time of use is:

SX7 MarkII: 1800 to 2000 hours
SX60

: 2400 to 2500 hours

z If the time of use is:

SX7 MarkII: 2000 hours or more
SX60

: 2500 hours or more

This projector uses the following lamp.
Lamp type No. SX7 MarkII: RS-LP04

SX60

: RS-LP03

z This message will not be displayed again if you select [Cancel] in response to the message

"Do you want to display this message again?".

z You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu

z When replacing the lamp, turn off the projector, wait until the cooling fan stops,

remove the power plug from the AC outlet, and let the projector stand for at least 1
hour. Otherwise, you may get burned because the main unit is very hot immediately
after the projector is turned off.

z Do not touch the inner glass surface when you replace the lamp. Otherwise, the pro-

jector's performance may degrade.

z Make sure to handle the lamp carefully and correctly since it may explode if it is

scratched or shocked.

z Do not remove screws unless specified.

z Be sure to use the specified lamp.

z A lamp can be ordered from your dealer or Canon home page.

* [<], [>], the [OK] button, and the [POWER]

button are available during this message
is displayed.

* The [POWER] button is available during

this message is displayed.