ASUS Essence One MKII MUSES Edition 用户手册

ASUS Essence One Series

9. Set screws

These 4 screws are used to hold the machine bed (including PCB board and power

module) and machine housing together. For repair’s sake, ASUS technicians may

need a small screwdriver to loosen the 4 screws to remove the front panel and then

draw the machine bed out for checking PCB board (or power module).

UNBALANCED

OUTPUT

BALANCED OUTPUT

DIGITAL INPUT

USB

TOSLINK

COAXIAL

VOLTAGE SELECTOR

AC IN

230

1. Unbalanced RCA Output (line-out)

Conventional stereo outputs for connection to the line-level phono/RCA inputs of a

speaker

NOTES:

• Most audio equipment has unbalanced audio inputs and outputs. This

means that the audio output (left, right, or mono) appears on a single

wire, and is referenced to “0V” or “Ground”. Typical connectors used are

RCA “phono” connectors and 1/4” (6.3mm) or 1/8” (3.5mm) jack plugs/

sockets.

• Unbalanced audio works well for short cable runs in low noise

environments. For long distances connection or complex setups where

RF noise may be a problem, Balanced XLR Output is recommended to

eliminate unwanted noises.

2. Balanced XLR Output(line-out)

ASUS Essence One Series also features true balanced (XLR) outputs. Connect

Essence One Series with equipment such as speakers of Balanced XLR connections.

NOTES:

• A lot of professional equipment will have balanced audio inputs and

outputs, usually on 3-pin “XLR” connectors. The line is said to be balanced

since the two signal carrying conductors are of equal (though opposite)

potential.

• Balanced XLR Output is a higher quality output that can reject noise and

interference with equipment with balanced inputs, especially perfect for

long cable runs or anywhere that induced noises might be a problem

Rear Panel