ASUS ST558 用户指南
Network connection
26
Remote network control
Once the display is connected via LAN connection, you can access the display’s built-in
remote network control interface using a computer and the display’s IP address.
remote network control interface using a computer and the display’s IP address.
Notes:
• The computer and display must have the same Subnet Mask, Default Gateway, Primary DNS and
• The computer and display must have the same Subnet Mask, Default Gateway, Primary DNS and
Secondary DNS settings.
• You cannot control the display via the RS-232C connection when LAN control is in use. However, you
can set the TCP port number of the LAN connection to 4660 if you want to control the display using
RS-232 protocol. See "RS232 commands over the network" on page 34.
RS-232 protocol. See "RS232 commands over the network" on page 34.
• The recommended Internet browser is Internet Explorer version 7.0 or higher.
1.
Enter the IP address of the display (can be found in the Setting > Information OSD
menu) in the address bar of the Internet browser and press Enter.
menu) in the address bar of the Internet browser and press Enter.
2.
The remote network control interface appears.
Information
The Information page provides general information about the display.