ASUS RS540-E8-RS36-ECP 用户指南

6-3

ASUS RS540-E8-RS36-ECP

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA 

hard disk drives attached to the SATA connectors supported by 

Intel

®

 C602 chipset. To do this:

1. 

Enter the BIOS Setup during POST.

2. 

Go to the Advanced Menu > PCH SATA Configuration, then press <Enter>.

3. 

Set SATA Mode to [RAID Mode]

4. 

Press <F10> to save your changes and exit the BIOS Setup.

Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.

Depending on the RAID connectors that you use, you can create a RAID set using the utilities 

embedded in each RAID controller. For example, use the Intel

 

if you installed Serial ATA hard disk drives on the Serial ATA connectors supported by the 

Intel

®

 C602 chipset.

Refer to the succeeding section for details on how to use the RAID configuration utility.

The motherboard supports Serial ATA for RAID set configuration. For optimal performance, 

install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:

1. 

Install the SATA hard disks into the drive bays following the instructions in the system 

user guide.

2. 

Connect a SATA signal cable to the signal connector at the back of each drive and to 

the SATA connector on the motherboard.

3. 

Connect a SATA power cable to the power connector on each drive.