ASUS PEB-10G/57840-2T 用户指南

1-4

Chapter 1: Product introduction

The PEB-10G/57840-2T Ethernet card is bundled with a full-length bracket, a low-profile

bracket, and an ASUS proprietary bracket. By default, the card is pre-installed with a full-

length bracket.

The proprietray bracket supports ASUS Z10PH-D16 series, ESC4000 G3 series, and

RS720Q-E8 series models, etc. The supported list of models are subject to change without

prior notice.

To replace the card bracket:
1.   Get the PEB-10G/57840-2T Ethernet card and place it on a stable and flat surface.

Ensure that the printed circuit board (PCB) is facing down.

2.  Remove the two screws that secures the PEB-10G/57840-2T Ethernet card to the card

bracket (A) then remove the card bracket (B).

3.  Get the replacement card bracket.

4.   Align and insert the PEB-10G/57840-2T Ethernet card into the mounting hole of the 

card bracket. Ensure that the screw holes on the PEB-10G/57840-2T Ethernet card 

matches the screw holes of the card bracket.

5.   Secure the card with the screws that you removed earlier in step 2.