ASUS PEB-10G/57840-2T 用户指南

ASUS PEB-10G/57840-2T

2-5

2.1.3

iSCSI Boot Configuration

Comprehensive Configuration Management v7.10.31

General Parameters

Initiator Parameters

1st Target Parameters

2nd Target Parameters

Secondary Device Parameters

iSCSI Boot Main Menu

Configure General Boot Parameters

[Enter]:Enter; [↑|↓]:Next Entry; [ESC]:Quit Menu

Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7

General Parameters

TCP/IP Parameters via DHCP [Enabled]
This option applies to IPv4.
[Enabled] The iSCSI boot host software acquires the IP address from the DHCP

server.

[Disabled] The iSCSI boot host software acquires the static IP address.

iSCSI Parameters via DHCP [Enabled]
[Enabled] The iSCSI boot host software acquires its iSCSI target parameters from

the DHCP server.

[Disabled] The iSCSI boot host software acquires its iSCSI target parameters via the

static IP address, which is entered through the iSCSI Initiator Parameters

Configuration screen.

CHAP Authentication [Disabled]
[Enabled] Allows the iSCSI boot host software to use CHAP authentication when

connecting to the iSCSI target. Enter the CHAP ID and CHAP Secret in the

Initiator Parameters configuration screen.

[Disabled] Does not allow the iSCSI boot host software to use CHAP authentication

when connecting to the iSCSI target.

Boot to iSCSI Target [Enabled]
[Enabled] The iSCSI boot host software immediately attempts to boot from the iSCSI

target after successfully connecting to it.

[Disabled] The iSCSI boot host software does not attempt to boot from the iSCSI

target after successfully connecting to it. The control will then return to the

system BIOS so that the next boot device may be used.

[One Time On the first system boot, the iSCSI boot host software does not
Disabled] attempt to boot from the iSCSI target. On subsequent system

reboots, the iSCSI boot host software will attempt to boot from

the iSCSI target. This option is useful when doing a remote

install of the OS to an iSCSI target.