Canon XA35 手册

Setting the Time Code

The camcorder can generate a time code signal and embed it in your recordings. In addition, the time
code will appear in the recordings output from the HD/SD-SDI terminal (

only) and HDMI

terminal. You can select whether the time code is output from the HDMI terminal (A 155). You can
also select between a drop frame and non-drop frame time code.

Selecting the Running Mode

You can select the running mode of the camcorder’s time code.

1 Open the [Time Code Mode] screen.

[FUNC.]

[MENU]

[Time Code Mode]

2 Touch the desired option.

• If you selected [

Preset], touch [K] and continue to step 3. If you selected [

Regen.],

touch [X]; you do not need to perform the rest of this procedure.

3 Touch [Time Code Running Mode].

• If you would like to set the time code’s initial value, see the following section Setting the Time

Code’s Initial Value.

4 Touch the desired option and then touch [X].

• If you selected [

Free Run], the time code will start running.

Options

(

Default value)

Setting the Time Code’s Initial Value

If you set the running mode to [

Preset], you can set the initial value of the time code.

1 Open the [Initial Time Code] screen.

[FUNC.]

[MENU]

[Initial Time Code]

• The time code setting screen will appear with the orange selection frame indicating the hours.
• To reset the time code to [00:00:00:00], select [Reset] instead.
• Touch [Cancel] to close the screen without setting the time code.

2 Touch [Í] or [Î] to change the field as necessary.

3 Touch another field you want to change (hours, minutes, seconds, frames).

4 Change the rest of the fields in the same way.

5 Touch [OK].

Operating modes:

[

Preset]

After you select this option, select a [Time Code Running Mode] option. With

[

Rec Run], the time code runs only when recording and scenes on the same memory card will

have a continuous time code; with [

Free Run], the time code runs regardless of the camcorder’s

operation. You can also choose to set the time code’s initial value for either [Time Code Running
Mode] option.

[

Regen.]

The time code runs while recording. Use this running mode to continue from the last

time code recorded on the memory card.