Canon Wi-Fi Adapter W-E1 手册

36

To start with, check if the access point supports WPS* that allows easy 
connection between Wi-Fi devices.
If you do not know if the access point you use is WPS-compatible, refer 
to the access point instruction manual or other documentation.

* Wi-Fi Protected Setup



When WPS is supported
The following two connection methods are available. Connection 
can be established easier with WPS (PBC mode).
• Connecting via WPS (PBC mode): Perform the operations 

described on page 37.

• Connecting via WPS (PIN mode): Perform the operations 

described on page 41.



When WPS is not supported
• Connecting to a detected network manually: Perform the 

operations described on page 45.

This camera supports the following options for [Authentication] and 
[Encryption settings]. Therefore, when connecting to a detected 
network manually, the encryption used by the access point must be one 
of the following.



[Authentication]: Open system, Shared key, or WPA/WPA2-PSK



[Encryption settings]: WEP, TKIP, or AES





When connecting to a network that has a network administrator, ask the 
administrator about the detailed setting procedures.

If the network you use filters by MAC address, register the MAC address of 
the W-E1 at the access point. The MAC address can be checked on the 
[General sett.] screen (p.72).