Canon PowerShot SX530 HS 手册

107

 

●

For information on WPS compatibility and for instructions on 
checking settings, refer to the access point user manual.

 

●

A router is a device that creates a network (LAN) structure for 
connecting multiple computers. A router that contains an internal 
Wi-Fi function is called a “Wi-Fi router”.

 

●

This guide refers to all Wi-Fi routers and base stations as “access 
points”.

 

●

If you use MAC address filtering on your Wi-Fi network, be sure 
to add the camera’s MAC address to your access point. You can 
check your camera’s MAC address by choosing MENU (= 29) 
> [

] tab > [Wi-Fi Settings] > [Check MAC Address].

WPS makes it easy to complete settings when connecting devices over 

Wi-Fi. You can use either Push Button Configuration Method or PIN 
Method for settings on a WPS supported device.

 

●

For instructions on checking the 
connection, refer to the device and 
access point user manuals.

 

●

Press the [

] button to turn the camera 

on.

 

●

Press the [

] button.

 

●

When the [Device Nickname] screen is 
displayed, press the [

] button. Use the 

keyboard displayed to enter a nickname 
(

screen, press the [

][

] buttons to 

choose [OK], and then press the [

] 

button.

Connect to your access point via Wi-Fi as follows.
Also refer to the access point user manual.

Confirm that the Wi-Fi router or base station conforms to the Wi-Fi 
standards in “Wi-Fi” (

Connection methods vary depending on whether the access point 
supports Wi-Fi Protected Setup (WPS, 

non-WPS access points, check the following information.

 

●

Network name (SSID/ESSID) 
The SSID or ESSID for the access point you use. Also called the 
“access point name” or “network name”.

 

●

Network authentication / data encryption (encryption method / 
encryption mode) 
The method for encrypting data during wireless transmission. Check 
which security setting is used: WPA2-PSK (AES), WPA2-PSK 
(TKIP), WPA-PSK (AES), WPA-PSK (TKIP), WEP (open system 
authentication), or no security.

 

●

Password (encryption key / network key) 
The key used when encrypting data during wireless transmission. Also 
called the “encryption key” or “network key”.

 

●

Key index (transmit key) 
The key set when WEP is used for network authentication / data 
encryption. Use “1” as the setting.

 

●

If system administrator status is needed to adjust network 
settings, contact the system administrator for details.

 

●

These settings are very important for network security. Exercise 
adequate caution when changing these settings.