Canon PowerShot SX410 IS Black 手册

30

 

●

You can change how long images are displayed after shots 
(

 

●

Before shooting a movie, lower the flash with your finger. Be 
careful not to touch the microphone (1) when shooting a movie. 
Leaving the flash raised, or blocking the microphone may prevent 
audio from being recorded or may cause the recording to sound 
muffled.

 

●

Avoid touching camera controls other than the movie button when 
shooting movies, because sounds made by the camera will be 
recorded.

 

●

Once movie recording begins, the image display area changes 
and subjects are enlarged to allow for correction of significant 
camera shake. To shoot subjects at the same size shown before 
shooting, adjust the image stabilization setting (

(1)

 

●

Audio recording is monaural.

 

●

Press the movie button again to stop 
shooting. The camera beeps twice as 
recording stops.

 

●

Recording will stop automatically when 
the memory card becomes full.

 

●

If the camera is turned on while the [

] button is held down, 

the camera will no longer sound. To activate sounds again, press 
the [

] button and choose [Mute] on the [

] tab, and then 

press the [ ][ ] buttons to choose [Off].

 

●

A blinking [

] icon warns that images are more likely to be 

blurred by camera shake. In this case, mount the camera on a 
tripod or take other measures to keep it still.

 

●

If your shots are dark despite the flash firing, move closer to 
the subject. For details on the flash range, see “Flash Range” 
(

 

●

The subject may be too close if the camera only beeps once 
when you press the shutter button halfway. For details on the 
focusing range (shooting range), see “Shooting Range” (

 

●

To reduce red-eye and to assist in focusing, the lamp may be 
activated when shooting in low-light conditions.

 

●

A blinking [ ] icon displayed when you attempt to shoot 
indicates that shooting is not possible until the flash has finished 
recharging. Shooting can resume as soon as the flash is ready, 
so either press the shutter button all the way down and wait, or 
release it and press it again.

 

●

Although you can shoot again before the shooting screen 
is displayed, your previous shot may determine the focus, 
brightness, and colors used.