Canon HJ18ex7.6B Series 产品宣传册

14

14

20pin

20pin

• ZSD-300D     

• ZDJ-D02*

1 

 

• ZDJ-P01*

2

 

 • FPD-400D

• FDJ-D02*

1 

    

• FDJ-P01*

2

  

*1   BDC-10 conversion cable is necessary to 

connect between ZDJ-D02 or FDJ-D02 

(18pin) and  Digital Drive Lens (20pin).

*2   BDC-20 conversion cable is necessary to 

connect between ZDJ-P01 or FDJ-P01 

(12pin) and  Digital Drive Lens (20pin).

Recognizing the importance of 3D program origination, Canon gave priority to adoption of most of the 

standard HD lens series for 3D production systems. This entailed use of Canon’s original 16bit resolution 

encoders, while at the same time allowing off sets of zoom, focus and iris positions to compensate the 

tracking of each positions. Canon is now introducing a new solution to construct a simpler 3D production 

system with increased interoperability at a low cost.

 A pioneer in the development of Digital Drive Units 

for its portable lenses, Canon’s new ergonomic 

Digital Drive Unit incorporates Canon-developed, 

ultracompact rotary encoders capable of 0.1µm 

position detection which produces 16-bit resolution 

of the positions of zoom, iris, and focus controls. 

The unique device allows for one zoom controller 

and one focus controller to simultaneously operate  

both lenses while providing even higher 

interoperability and precision in synchronization of 

zoom, focus and iris positions of the lens pairs.

 The “3D Lens Adjustment Software” is intended to make stereoscopic 

tracking of the zoom, focus and iris even more precise, and allow 

appropriate offsets to be easily made using the Digital Drive Unit’s 

display to compensate for minor zoom and focus tracking differences 

between any two lens pairs (zoom:3points, focus:2points, iris:2points).

Another attraction of Canon’s synchronous lens control system is that 

the system doesn’t require special controllers. If the lens is installed with 

the 3D Lens Adjustment Software, all the servo controllers for digital 

servo lenses as shown below will be compatible by connecting the two 

lenses with the simple 3D Bridge Cable (BC-100), which should save 

additional costs when implementing 3D production systems.

To Left Lens

To Right Lens