Canon DIGISUPER 22 xs 手册
E4-19
4. Menu screen – User
User 0
Reset Now
With User 0
Escape To User 0
With User 1 to 9
1
0
VTR
A 1
FRM1
A 2
V
RET
R
[ ]
Menu
[ IND ]
EXT
I G : 5 0
Any screen
VTR
A 1
FRM1
A 2
V
RET
R
[ ]
Menu
[ IND ]
EXT
I G : 5 0
Top initial screen
or
User – Escape operation
Escape operation
When the power is turned on again:
The same user who was using the system prior to the jump operation is selected. However, if the user was
changed after the jump operation was performed, the user using the system after the change was made is
selected instead.
changed after the jump operation was performed, the user using the system after the change was made is
selected instead.
※
(NOTE): Even when the jump operation is performed, the settings of the following items will remain the same
as before the jump operation: auto iris gain value, remote iris gain value, F-Hold setting, encoder
output setting, IND screen follow-up display settings,default screen settings,Switchable setting and
Adjustment of Camera Fol Voltage.
output setting, IND screen follow-up display settings,default screen settings,Switchable setting and
Adjustment of Camera Fol Voltage.
※
(NOTE): The jump operation cannot be performed in the lock status.
2sec
Set
and
DISPLAY
[
]
This operation makes it possible to jump from the current setting status of the user (any user from 0 to 9) to the user 0
setting status (factory setting status) in an instant.
setting status (factory setting status) in an instant.
1. Hold down the DISPLAY switch and
Set
key for more than 2 seconds.
The following message is displayed depending on the user who was using the system prior to
the jump operation.
User 0: User 0 Reset Now
User 1 to 9: Escape To User 0
2. The Top initial screen is displayed.