Netgear RD5D (ReadyDATA Disk Packs) – ReadyDATA Disk Packs (SATA/NL-SAS/SAS/SSD) 软件指南
Backup, Replication, and Recovery
214
ReadyDATA OS 1.4
6.
If you are configuring a new job without a seed, skip this step, otherwise select the snapshot
to use as a base for replication and click Next.
to use as a base for replication and click Next.
The next Continuous Replicate screen displays:
7.
Configure the settings on the screen as explained in the following table:
Item
Description
New data set name
Enter a name for the share or LUN on the destination system.
Advanced Settings for Data Transmission
Compression
Select the check box to enable data compression during the data transfer. Then
configure the compression rate. By default, compression is disabled.
configure the compression rate. By default, compression is disabled.
Note:
After the data has been transferred, the data is not stored compressed
unless it was already compressed on the source share or LUN.
Compression Ratio Select the compression rate by making a selection from the
drop-down list. You can select from 1 through 10, and
unlimited. For example, 5 indicates that data is compressed
five times.
unlimited. For example, 5 indicates that data is compressed
five times.