KitchenAid 1.4 Cu. Ft. Built-In Trash Compactor with Display, Architect® Series II 使用和维护
8
Installation
1. Remove the mounting screws attaching the foot pedal to the
compactor. Remove the foot pedal.
2. Remove the mounting screws attaching the toe guard to the
compactor. Remove the toe guard.
3. Remove the mounting screws attaching the decorative panel
to the compactor. Remove the decorative panel and discard
the mounting screws.
the mounting screws.
4. Align the bottom of the custom panel with the bottom of the
drawer front.
5. Secure the panel from the back using four #8 x 1" wood
screws as shown.
6. Attach a 15" x
¹⁄₂" (38.1 cm x 13 mm) quarter-round filler
along the top of the drawer front using glue or screws.
7. Reinstall the toe guard using the existing screws and
¹⁄₂"
washer. Then, reinstall the foot pedal.
COMPACTOR USE
How Your Compactor Works
The compacting ram is the part of the compactor which
compresses the trash. The compacting ram does not go to the
bottom of the drawer. You will not see compacting of trash the
first few times you load the compactor.
compresses the trash. The compacting ram does not go to the
bottom of the drawer. You will not see compacting of trash the
first few times you load the compactor.
NOTE: The compactor drawer should be more than
¹⁄₂ full before
the compactor can begin to compress the load.
You may hear a noise when glass breaks. Strong glass bottles
may not break at all. The trash in a full compactor bag will be
about
may not break at all. The trash in a full compactor bag will be
about
¹⁄₄ the size of its original bulk.
Load bulky trash, bottles, and cans in the center of the drawer.
Bottles or cans not placed in the center may become caught
between the ram and the drawer. The Drawer Monitor Switch
then senses a “misload” and causes the ram to return to the “up”
position without compacting.
Bottles or cans not placed in the center may become caught
between the ram and the drawer. The Drawer Monitor Switch
then senses a “misload” and causes the ram to return to the “up”
position without compacting.
A. Mounting screws
B. Foot pedal
B. Foot pedal
A
A
B
A. Custom panel
B. 15" x
B. 15" x
¹⁄₂
" (38.1 cm x
13 mm) quarter-round filler
C. Panel screw
locations
D. Toe guard
E. Washer
F. Toe guard
screw
A
B
D
E
F
C
C